Technical Requirements:
1.(Acrylic Forming Machine,Bath Machine,Blister machine,Bathroom Equipment) Plywood Size: 6000 × 2540 × (1-6) mm
2.(Acrylic Forming Machine,Bath Machine,Blister machine,Bathroom Equipment) Forming station Mast Lifting stroke: 1400mm
3. (Acrylic Forming Machine,Bath Machine,Blister machine,Bathroom Equipment)Heating method: multi-block area of small quartz heating plate heating, the percentage of energy to control the heating control each heating plate, computer-programmable controller. SCR power control electronics.
4.(Acrylic Forming Machine,Bath Machine,Blister machine,Bathroom Equipment) Cavity stainless steel, color steel shell. 150MM insulation layer (bulk density 90KG / m3).
5. Temperature rose to 200 º C the time required is less than 30 minutes.
6. Bake plate temperature difference: ± 20 º C.
7. Each cylinder can be independently set parameters, edit, save, and call at any time.
8. Splints force: rapid clip clamping force of each 150kg, can be equipped with pneumatic splint.
With 4 per meter rapid clip, and set up insurance to ensure they do not slide.
9. Splints sports car with slow start, the middle of fast run, slow stop in place to ensure fast and accurate positioning.
11. Lifts travel: 1000mm (adjustable). Molding Height 1200-1550 mm.
12. Lift the power of exposure: a low point of> 4T, the roof location> 10T
13. Lift during lifting height deviation: ± 3mm
14. Lift off and landing speed: l <10S, down <12S.
15. Suction plate suction force / pressure / volume: intensity of> 150kg /
Evacuated Tube <0.5M ³.
16. Plate height above ground is: 1150mm
17. Cylinder dual two inches of vacuum forming Drainage double solenoid valve, suction cup suction plate frame manual, suction cup holder for the electric lift, move around the electric suction frame.
18. Above action can be manual and automatic operation.